Redline Communications RDL-2000 Instrukcja Obsługi Pobierz pdf (Strona 30)

RDL-2000 Installation Guidelines

4.4.3 Disconnecting the Ethernet Cable

The RJ-45 connector is recessed within the RDL-2000 chassis. To disconnect the

Ethernet cable from the RDL-2000, you must use a small flat blade screwdriver or similar

tool release the locking tab located in the chassis recess.

1. Use a small flat blade screwdriver or similar tool to carefully depress the locking tab

on the Ethernet plug.

2. Maintain pressure on the tab and use only a light pull (two fingers) to remove the

Ethernet plug from the socket. The cable must be pulled straight out the port or the

connector may be caught on the chassis metal housing.

Ethernet Cable Removal

Use of excessive force when removing the Ethernet cable will damage the RJ-45

connector and the RDL-2000 printed circuit board.

If the wea

therproofing grommet has been installed, care must be taken to avoid

excessive strain on the RJ-45 connector when moving the grommet to gain access the

release pin on the connector. Be sure to push

the Ethernet cable through the grommet

hole as the grommet is moved away from the RDL-2000 port.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Brak uwag

Redline Communications RDL-2000 Instrukcja Obsługi Strona 30